Display all pictures
Condition: New product
Warning: Last items in stock!
11 940,00 €
Add to cart
The minimum purchase order quantity for the product is 1
Manual Bottle Filler H4
The filler comes with eight filling stations. It consists of a pressure tank (filler bowl),
pressure gauge/relief valve, sight glass, CO² or Nitrogen inlet valve, product inlet valve, float switch/valve, bottle pads, tension
springs and bottle safety shields.
The filler works on the basis of pressure balance. The filler bowl is counter pressurized with either CO² or Nitrogen through the
ball valve. The counter pressure can be easily done by directly adding CO² or Nitrogen from a cylinder complete with regulator
The beer can slowly flow into the pressure tank (filler bowl) due to the escape of the already present pressure. This can be
observed in the sight glass located at the side of the filler bowl and the sound of the CO² blowing off from the float switch.
When the beer has reached its maximum level in the pressure tank, the float switch shuts automatically. This will stop the beer
from entering into the filler bowl. The filling of the bottles can begin.
Place a cold rinsed bottle between the filling valve and the bottle pad (tension spring). Then press the hand lever/safety guard
downwards. This will activate the filling valve to counter pressure/fill the bottle.
Repeat the above mentioned procedure for the rest of the filling stations. Once all the filling stations have been placed, go
back to the first filling station and remove the bottle.
For the filling of bottles from 0,33 - 2 litre up and Syphon bottles, we have to
charge for each filling position an additional price of € 295,--
( Spring, other suspension and other seals).
All H4 filler can be fitted with the following mentioned add-on’s
Product category catalog